Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ6B-(M16-M20)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
Datasheets(X)
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 45 x 18 mm |
Last viewed
Allen key, hexagon socket
T-handle screwdriver with bit strip, 10 pcs and PH2 bit
Engine Oil Pentathlon SAE 5W-30
30-mm flat chisel, hex.
1/4" socket wrench insert slotted
Twist drill bit HSS DIN 338 type RN 130°
Twist drill bit HSS DIN 338 type RN 130°
Hammer drill H 8-28-CLASSIC
1/2 inch extension
Twist Drill bits HSS ASME B94.11M TYPE RN